K2 CNC Router - Mach 3 - Guitar Body - Cutting Guitar
K2 CNC Router - Mach 3 - Guitar Body - Cutting Guitar
This is a K2 CNC router cutting a guitar body. A Colombo spindle is used. The project uses roughing and finish passes. The bit cuts a depth of 1.5 inches. This project takes about 13 minutes. This was a test or demo run with little enhancements of the program to make the cutting faster. I am sure a Luthier can make the project cut faster. The KG-3925-GC machine is often used for inlay, body, necks, 3D and 2D cutting also. The machine runs about $15,000, but basic machine starts at about $11,500. A similar machine will be a NAMM 2008.
This is a K2 CNC router cutting a guitar body. A Colombo spindle is used. The project uses roughing and finish passes. The bit cuts a depth of 1.5 inches. This project takes about 13 minutes. This was a test or demo run with little enhancements of the program to make the cutting faster. I am sure a Luthier can make the project cut faster. The KG-3925-GC machine is often used for inlay, body, necks, 3D and 2D cutting also. The machine runs about $15,000, but basic machine starts at about $11,500. A similar machine will be a NAMM 2008.
ป้ายกำกับ: CNC ROUTER
posted by SEAGAMES 2009 @ 20:19,
